12 Bend-Tech Dragon
Material Coolant System Assembly
02
Material Coolant System Assembly Manual
2.2.5 Attach Water Tray to Parts Catcher
When assembling the coolant trays,
the face of the tray is placed behind
the parts catcher in the same fashion.
the parts catcher.
Use one of the support legs to support
the free end of the Water Tray. Use
four ¾ in. button head screws, nuts
and washers to attach the side tabs on
the coolant tray to the parts catcher.
Feed the screws through the side of the
coolant tray so the head of the screw is
inside the coolant tray and the nut and
washer are on the outside.
Use a punch or small Phillips head screwdriver to help align the mounting holes in the
Water Tray system.
Head of Machine
Tray 1
Support Leg
Beak
Parts Catcher
Parts Catcher
Tray 1
To Next Page
Loading...
Need help?
General
