Operation and setting
30
RCMA423_D00063_03_M_XXEN/03.2021
5.5.6 Changeover from overcurrent to undercurrent mode or to
window mode
The operating mode can be changed in the SEt/I 12 menu using the parame-
ters HI, Lo and In. By default, overcurrent operation (HI) is set.
Changing from overcurrent operation to window operation
Use this menu item to set whether the response values of the device apply to
overcurrent (HI) or undercurrent operation (Lo). In addition, window operati-
on (In) can be selected.
5.5.7 Factory setting and password protection
Use this menu to activate the password protection, to change the password
or to deactivate the password protection. In addition, you can reset the device
to its factory settings.
a) Activating the password protection
12
I
12
I
12I12I
2x
>1,5 s
on
o
12I
2x
>1,5 s
To Next Page
Loading...
Need help?
General
