Introduction
| 16 |
© Honeywell International Inc. Do not copy without express permission of Honeywell.
KFC 230 AeroCruze Autopilot Pilot's Guide
89000019-001
Rev 2 May 2019
Additionally, when the system detects a KC or KMC Software (SW)
Power-Up Built-In Test (PBIT) part number mismatch or failure, a
.CHECK SOFTWARE VERSION message is displayed with a list of all six
SW part numbers. Contact your local BK dealer for additional support.
Figure 8 Check Software Version
Maintenance Mode may be entered when connected to maintenance &
test equipment (laptop), or manually by the user’s action during power-
up. This mode will remain displayed until exiting maintenance mode.
Figure 9 KFC 230 Maintenance Mode
REF:
To Next Page
Loading...
