BendPak HDS-14LSX - Page 25

HDS-14LSX / HDS-14LSXE Lifts 25 P/N 5900162 — April 2018 — Rev. F3
Use a Forklift or Shop Crane to raise the Runways and move them into position.
⚠ WARNING Pay close attention when moving the Runways into position; they are very heavy
and very long, and could shift position or fall, potentially causing serious injury.
To install the Runways:
1. Correctly orient the Powerside Runway and the Offside Runway.
See the previous page for more information.
2. On the Powerside Runway, remove the Cable Sheaves.
To remove the Cable Sheaves: unscrew the Sheave Pin Lock Screw (on the underside of the
Sheaves), pull out the Sheave Pin, then remove the Cable Sheaves.
There are four Cable Sheaves at the Rear of the Lift (near the Power Post) and two Cable Sheaves
at the Front of the Lift. You need to remove all six.
Note: Keep all of the components nearby, you will be putting them back in shortly.
3. When the Cable Sheaves have been removed, use a Forklift or Shop Crane to pick up the
Powerside Runway and move it into place on the Powerside of the Lift.
Make sure the Utility Rail is on the inside .
4. Bolt the Powerside Runway into place, two Bolts on each end going into the Crosstubes.
Use four M12 by 1.75 by 90 Hex Head Bolts.
5. Using a Forklift or Shop Crane, pick up the Offside Runway and move it into place between the
Stop Blocks.
Make sure the Utility Rail is on the inside .
The Offside Runway does not have any Cable Sheaves, nor does it bolt into place.
6. Check all of the Safety Locks to make sure they are engaged.
You do not want anyone going under the Runways unless the Safety Locks are engaged.
⚠ WARNING Do not continue with the installation until you have visually confirmed that all four
Safety Locks are engaged. If they are not engaged, the Runways could move or
fall, possibly causing personal injury or product damage.