BendPak P-9000LT - Introduction and Critical Warnings; Lift Overview and Applications; Critical Installation and Operation Hazards

P-9000LT/F Low-Rise Pit Lift 3 P/N 5900022 — Rev. B — Nov. 2019
Table of Contents
Introduction 3 Operation 41
Shipping Information 4 Lift Arm Kit 46
Safety Considerations 4 Maintenance 48
Components 5 Troubleshooting 49
FAQs 7 Wiring Diagrams 50
Specifications 8 Labels 52
Installation Checklist 10 Parts Diagrams 55
Installation 11 Maintenance Log 63
Introduction
This manual describes the P-9000LT and P-9000LTF, which are low-rise, frame-engaging, pit lifts that
are designed and engineered for fast-paced auto shop environments, oil-change facilities, and home
garages. They can be installed at ground level or recessed (the F in P-9000LTF stands for “flush
mount”), generally over a service pit. Flush mount models do not use ramps, but they do require a
recessed surface.
Both models raise Vehicles up to 9,000 lbs (4,082 kg). Both models are ALI certified (autolift.org)
when used with a 220 VAC Power Unit.
More information about the full line of BendPak products is available at bendpak.com.
This manual is mandatory reading for all P-9000LT/F users, including anyone who installs, operates,
maintains, or repairs them. You can always find the latest version of the manual for your product
on the BendPak website.
⚠ DANGER Be very careful when installing, operating, maintaining, or repairing this equipment;
failure to do so could result in property damage, product damage, injury, or (in very
rare cases) death. Make sure only authorized personnel operate this equipment. All
repairs must be performed by an authorized technician. Do not make modifications
to the unit; this voids the warranty and increases the chances of injury or property
damage. Make sure to read and follow the instructions on the labels on the unit.
Keep this manual on or near the equipment so that anyone who uses or services it can read it.
If you are having issues, refer to the Troubleshooting section of this manual for assistance.
Technical support and service is available from your dealer, on the Web at bendpak.com/support,
by email at techsupport@bendpak.com, or by phone at (800) 253-2363, extension 196.
You may also contact BendPak for parts replacement information (please have the model and serial
number of your unit available) at (800) 253-2363, extension 191.