P-9000LT/F Low-Rise Pit Lift 45 P/N 5900022 — Rev. B — Nov. 2019
⚠ WARNING If the Lift becomes unstable, release the Raise button and immediately evacuate
the area. If safe to do so, carefully lower the Platforms back down to the ground.
10. Release Raise when the Vehicle’s wheels are about 6 in / 152 mm off the ground.
The Platforms stop.
11. Make sure all four Lift Blocks are in firm contact with the factory-recommended Lifting Points.
If the Lift Blocks
are
in the right positions, do not move them.
If the Lift Blocks are
not
in the right positions, press and hold Lower and
carefully
return the
Vehicle to the ground, then restart the process from the beginning.
12. If the Lift Blocks are in the right positions, rock the Vehicle gently to test for stability.
If the Vehicle is stable, press and hold Raise to continue raising Vehicle.
If the Vehicle is
not
stable, press Lower and
carefully
return the Vehicle to the ground, then
start the raising process from the beginning.
13. To engage both Platforms on Safety Locks, raise the Vehicle just past the desired Safety Lock (you
will hear a clank when it passes), release Raise, then press Lower.
The Platforms will stop moving down when they engage on the Safety Locks; release Lower.
⚠ WARNING Before doing anything else (like working on the Vehicle or leaving the area),
visually
confirm
that
both
Platforms are engaged on the same Safety Locks and all Lift
Blocks are in stable contact with the Vehicle’s factory-recommended Lifting Points.
14. Confirm that both Platforms are engaged on the same Safety Locks and that all Lift Blocks are in
stable contact with the Vehicle’s factory-recommended Lifting Points.
Lowering a Vehicle
This section describes how to lower a Vehicle from a raised position.
To lower a Vehicle:
1. Check the items listed in Safety First.
If you find any issues, resolve them
before
attempting to lower a Vehicle.
2. At the Console, press and hold the Raise button for a couple of seconds.
This moves the Platforms off the Safety Locks, which is required for them to lower.
3. Press and hold the Safety Lock Release button, then press and hold the Lower button.
Pressing and holding the Safety Lock Release button causes the Air Cylinder to push up and
hold up the Lock Release Bar, preventing the Lock Bar from engaging on Safety Locks as the
Platforms lower. If you do not press and hold the Safety Lock Release button, the Platforms
will engage on the closest Safety Lock instead of lowering.
The Platforms begin lowering.
⚠ WARNING If the Lift becomes unstable at any point before it is fully lowered to the ground,
release the Lower button and immediately evacuate the area. If safe to do so,
return to the Console and carefully lower the Platforms back down to the ground.
4. When the Platforms are fully lowered, release both buttons.
To Next Page
Loading...
