39
LIFT OPERATION SAFETY (CONT’D)
4. Position vehicle for proper weight distribution arms
under vehicle to allow adapters to contact at the
manufacturer’s recommended pick up points.
5. If the specic vehicle lift points are not identied, refer
to the VEHICLE CENTER OF BALANCE instructions
found on our website at:
www.bendpak.com/support/balancing-safety/
Fig. 19.2
TYPICAL LIFTING POINTS
Fig. 19.3
MANY SPECIALTY OR MODIFIED VEHICLES
CANNOT BE RAISED ON A TWO-POST FRAME
ENGAGING LIFT. CONTACT VEHICLE
MANUFACTURER FOR RAISING OR JACKING
DETAILS.
NOTE:
ALLOW (2) SECONDS BETWEEN MOTOR STARTS.
FAILURE TO COMPLY MAY CAUSE MOTOR
BURNOUT.
To Next Page
Loading...
Need help?
General
