XPR-9 Series Two-Post Lifts
25
P/N 5900371 — Rev. D2 — May 2023
4. Place the Chain Roller Assembly (5210117) on the Lift Cylinder Rod.
5. Connect and secure one end of the Chain Assembly to the Base Plate anchor using the Master
Link.
6. Thread the Chain around the Chain Roller and through the Lift Head.
7. Anchor the end of the Chain to the Lift Head Connector Bracket on the inside of the Lift Head.
Refer to the figure below.
8. Visually inspect the Lift Head Chain is properly positioned with the Lift Head Chain Sheave.
To Next Page
Loading...
