XPR-9 Series Two-Post Lifts
29
P/N 5900371 — Rev. D2 — May 2023
9. Wrench each Nut clockwise to the recommended
installation torque, 85 – 95 pound feet, using a
Torque Wrench.
Important: Do not use an impact wrench to torque
the Anchor Bolts.
Routing the Safety Lock Cable
The following procedure describes how to put the Safety
Lock Cable into place; it does not describe how to
attach it to the Safety Lock Assemblies.
The following drawing shows the path the Safety Lock
Cable travels to each Safety Assembly.
Drawing not to scale. Components removed for clarity. The Safety Assemblies are not installed at this
point, so the Safety Lock Cable, after being routed, will simply stay in place until later in the installation.
To Next Page
Loading...
