XPR-9 Series Two-Post Lifts
30
P/N 5900371 — Rev. D2 — May 2023
To route the Safety Lock Cable:
1. Locate the Safety Lock Cable for your Lift.
2. Starting on the inside of the Offside Post, push the loop end of the Safety Lock Cable
out through the opening in the Offside Post; leave the loop end hanging out of the hole, for now.
3. Route the other end (the non-loop end) of the Safety Lock Cable over the Safety Sheave,
downwards on the inside of the Offside Post, under the Safety Sheave at the bottom of the Offside
Post, across the Lift floor, under the Safety Sheave at the bottom of the Power Side Post, then
upwards, on the inside of the Power Side Post, towards the Mounting Bracket.
4. On the Power Side Post, when the non-loop end of the Safety Lock Cable is near the
Mounting Bracket, route it over the Safety Sheave, then push it through the opening in the Power
Side Post.
5. The Power Side Safety Assembly is not yet installed, so just leave the non-loop end of the Safety
Lock Cable hanging out of the hole. Both ends of the Safety Lock Cable will be appropriately
connected during the procedure to install the Safety Assemblies.
⚠ CAUTION When connecting the ends of the Safety Lock Cable later in the installation, make
sure the Cable stays in all of the Safety Sheaves. This keeps it out of the way of the
Hydraulic Hoses and Equalizing Cables.
Connecting the Safety Lock Cable – XPR–9TF only
Your XPR-9 Series Lift has two Safety Assemblies: one on the Power Side Post (above the Power Unit)
and the other on the Offside Post.
The Safety Assemblies take the Lift off of its Safety Locks so the Lift Arms can be lowered. The Safety
Assemblies need to be disengaged at the same time so that the Lift Arms lower together. In order to
do this, the two Safety Assemblies are connected to each other via the Safety Lock Cable.
Routing the Safety Lock Cable was done earlier; refer to Routing the Safety Lock Cable for
additional information.
The Power Side Safety Assembly includes a Safety Lock Release Handle, which angles up and is
used to lower the Lift.
To Next Page
Loading...
