XPR-9 Series Two-Post Lifts 32 P/N 5900371 — Rev. D2 — May 2023
2. Insert the Safety Clevis Pin, from the right, through the hole in the right welded plate, then through
the Power Side Safety Weldment, and then through the left welded plate.
3. Position the Torsion Spring on the left end of the Safety Clevis Pin, then install the Hair Pin on the
end of the Safety Clevis Pin.
4. Repeat Steps 1 through 3 for the Offside Safety Assembly on the Offside Post.
To connect the Safety Lock Cable:
1. Starting on the Offside Post, route the loop end of the Safety Cable over the short, lower
Welded Pin, past the Safety Clevis Pin, and loop it over the right end of the longer, Welded Pin.
2. Secure a Rotor Clip to the short, lower Welded Pin to keep the Cable in place.
3. Moving to the Power Side Post, screw two Nuts and Washers onto the threaded end of the
Welded Pin with Threads. Make sure that one Nut and one Washer is on each side of the hole in
the Welded Pin with Threads.
4. Put the non-loop end of the Safety Cable over the front of the Welded Pin and into the hole in the
Welded Pin with Threads, between the two Nuts and the two Washers.
5. Pull any slack out of the Safety Cable, then tighten the Nuts.
⚠ CAUTION When tightening the Nuts, keep tension on the Safety Cable and keep the Safety
Cable centered between the two Nuts.
6. Operate the Safety Lock Release Handle, checking for proper operation of both Safety Assemblies.
⚠ DANGER Verify that both the Power Side and the Offside Safety Assemblies engage properly
before operating the Lift.
To Next Page
Loading...
