XPR-9 Series Two-Post Lifts
52
P/N 5900371 — Rev. D2 — May 2023
Installing the Safety Covers – XPR-9TF only
There are two Safety Covers, one for each Safety Assembly, on the outside of each Post.
Refer to Installing the Safety Assemblies and the Safety Lock Cable for more information
about installing the Safety Assemblies.
The Safety Covers are not interchangeable:
• The Offside Safety Cover can be installed in either orientation. It does not have a slot.
• The Power Side Safety Cover can only be installed in one orientation: there is a slot on the front for
the Safety Lock Release Handle.
Both Safety Covers connect to their Posts via blocks in the upper left and lower right corners.
To install the XPR-9TF Safety Covers:
1. Locate the two Safety Covers and four Cover Screws.
2. On the Offside Post, install the Cover Screws in each block, making sure to leave enough
space between the Block and the Cover Screws to slide in the Safety Cover.
3. Slide the Offside Safety Cover for the Offside Post into position, then fully tighten both Cover
Screws into their blocks so that the Safety Cover is held securely.
4. On the Power Side Post, install the Cover Screws in each block, making sure to leave enough
space between the Block and the Cover Screws to slide in the Safety Cover.
5. Slide the Power Side Safety Cover for the Power Side Post into position, then fully tighten both
Cover Screws into their blocks so that the Safety Cover is held securely.
6. Fully tighten both Cover Screws into their blocks so that the Safety Cover is held securely.
To Next Page
Loading...
