XPR-9 Series Two-Post Lifts
7
P/N 5900371 — Rev. D2 — May 2023
29. Modifications void the warranty and increase the chances of injury or property damage. Do not
modify any safety-related features in any way.
30. Make sure all operators read and understand this Installation and Operation Manual. Keep the
manual near the Lift at all times.
31. While handling a Hydraulic Cylinder or a Hydraulic Hose,
always
wear gloves. In rare cases, a
needle-like stream of hydraulic fluid (even at low pressure) can penetrate fingers, hands, or arms;
such a puncture can feel like a bite, electric shock, or a prick. While it may seem like a minor issue,
any amount of Hydraulic Fluid injected into the human body is a serious issue. Anyone suffering
such a puncture wound should be
immediately
taken to a hospital emergency room to
determine the extent of the injury. Explain the circumstances of the injury to the attending
physician, including what kind of Hydraulic Fluid was involved. Do not assume a puncture wound
that could have been caused by Hydraulic Fluid is a minor issue; it could be life threatening.
32. Make an inspection of the Lift
before
using it. Check for damaged, worn, or missing parts. Do not
use it if you find any of these issues. Instead, take it out of service, then contact an authorized
repair facility, your dealer, or BendPak at (877) 432-6627 or support@BendPak.com.
Symbols
Following are the symbols used in this manual:
⚠ DANGER Calls attention to an immediate hazard that will result in injury or death.
⚠ WARNING Calls attention to a hazard or unsafe practice that could result in injury or death.
⚠ CAUTION Calls attention to a hazard or unsafe practice that could result in minor personal
injury, product, or property damage.
NOTICE Calls attention to a situation that, if not avoided, could result in product or property
damage.
Tip Calls attention to information that can help you use your product better.
Liability Information
BendPak Inc. assumes no liability for damages resulting from:
• Use of the product for purposes other than those described in this manual.
• Modifications to the equipment without prior, written permission from BendPak Inc.
• Injury or death caused by modifying, disabling, overriding, or removing safety features.
• Damage to the equipment from external influences.
• Incorrect operation of the equipment.
To Next Page
Loading...
Need help?
General
