Benelli 752S - Page 19

3 - 4
Instrument and control functions
EN
3
1. LH direction indicator light
The left indicator light will ash when the
corresponding direction indicator lights
are activated.
2. RH direction indicator light
The right indicator light will ash when
the corresponding direction indicator li-
ghts are activated.
3. High beam indicator light
This warning light comes on when the he-
adlight is in the high beam position.
4. Neutral indicator light
This indicator light comes on when the
transmission is in the neutral position.
5. Water temperature warning lamp
When the light comes on, stop and check
the water tank.
6. Total kilometre counter
The totalizer odometer records the total
mileage driven.
7. Water temperature indicator
This indicator indicates the temperature
of the coolant. When the pointer is betwe-
en C and H, the temperature is normal.
You should stop and check the coolant
reservoir if the pointer is higher than the
H level.
8. Gear engaged indicator light
The numbers on the indicator indicate the
positions of the gearbox and gear enga-
ged (1, 2, 3, 4, 5 and 6).
9. Tachometer
The speedometer indicates the rotation of
the engine per minute.
10. Speedometer
The odometer indicates the driving spe-
ed, kilometers / hour.
11. Oil pressure warning light
When this indicator lights up, it means
that the lubrication is insucient and the
bike must be checked / repaired immedia-
tely.
12. Partial kilometre counter
Trip meter can be reset, which records the
mileages driven in a specic period.
13. Fuel reserve warning light
Indicates that the fuel is less than 15% of
the total capacity of the fuel tank.
14. Digital clock
Indicates the time expressed in hours and
minutes.
15. Engine fault indicator light
This warning light comes on if a fault is
detected on the engine or another vehicle
control system. If this happens, have the
on-board diagnostic system checked by a
Benelli dealer.
16. Fuel gauge
Indicates the fuel level in the tank.