Benelli TNT300 - Motorcycle Stopping and Parking Procedures; Motorcycle Stopping Technique; Parking and Security Measures

Twist the throttle grip in the direction away from yourself to close the throttle. Use front and rear brake evenly.
Shift to low speed gear to slow down.
Before stopping the motorcycle, hold the clutch and shift to neutral position. Check the neutral position indicator
light to check whether it is in neutral position.
Notice:
Inexperienced drivers usually use rear brake only, which will accelerate abrasion of the brake and result
in longer stopping distance.
Warning:
It is dangerous only to use either the front brake or rear brake which may causes the motorcycle to skid or
lose control. Be careful and use brakes properly when you drive on wet road or curved road.
The motorcycle should be parked on £rm and £at road. If you have to park the motorcycle on a slope by the side
stand, please shift to the £rst gear to prevent slipping. Shift to neutral position before starting the engine.
Turn the power key to the position " " to stop the engine.
Remove ignition key from the switch after locking for security reason.
27
TNT300