Benelli TNT300 - Motorcycle Storage Guidelines; Long-Term Storage Preparation Steps

Tire Tread
Driving a motorcycle with wheels excessively worn will reduce driving stability or even get out of control. When
the tire tread of front wheel is less than 1.6mm, and the rear wheel's tread is less than 2mm or even less,
replacement is strongly recommended.
STORAGE GUIDELINE
Storage
If you need to keep your motorcycle for a long time without using, it's suggested tofollowing these instructions:
1. Change engine oil.
2. Lubricate drive chain
3. Detach the spark plug and add one teaspoon of (15~20cm3) clean engine oil to cylinder. Pushing the
starting switch for several times to distribute oil in the cylinder, and install the spark plug again.
4. Remove the battery. Keep the battery in proper place which can avoid freezing and the direct sunlight.
5. Clean and dry the motorcycle. Wax the surface of the paint.
6. In£ate tire to the required pressure. Put the motorcycle on a block to make two tires oF the ground.
7. Cover the motorcycle (no plastic or coating material) and keep it in the place with consistent temperature
and low humidity. Do not keep your motorcycle under direct sunlight.
45
TNT300