Benelli TNT300 - Battery Electrolyte Filling Process; Battery Electrolyte Filling Steps; Electrolyte Filling Process Notes

a. Place vertically the battery on a horizontal plane and remove the sealing tape.
b. Take out the electrolyte from the plastic bag. Open its cover strip and use it as £lling plug for the battery.
Attention: Please do not tear or puncture the sealing tape on the £lling port.
The cover strip can be kept as £lling plug for the battery.
c. Lift the electrolyte container upside down vertically and align the six £lling ports of the container with the six
£lling ports on the battery. Pull downward hard the electrolyte container so as to puncture the sealing tape on the
£lling ports of electrolyte container. Electrolyte thus £ows from the container to the battery. Check the three £lling
pipes on both sides. At least there is one pipe that has bubbles coming out on each side, which means that
electrolyte £lling begins normally. Attention: Please be sure not to tilt the container, or electrolyte £lling may be
interrupted.
d. When you are sure that there is at least one pipe that has bubbles coming out on each side (three pipes on
each side), leave it there and keep the £lling process over 20minutes.
If there is no pipe that has bubbles coming out on each side, tap slightly two to three times the bottom of the
electrolyte container and check again if there is at least one pipe that has bubbles coming out on each side (The
electrolyte cannot be taken down now).
e. When the electrolyte has completely £owed through, tap the container bottom several times to drain residual
electrolyte; and then slowly pull out the electrolyte container.
35
TNT300