Adjust
the
chain
in following methods:
1. Support
the
motorcycle
with
side
stand.
2. Loosen rear axle
nut.
3. Loosen
locknut.
4. Turn adjusting
nut to
adjust
the
tightness
of the
chain. Reference marks are adopted
on left
and
right swing
arm and should reach
the
same
grid
after adjustment. Retighten
the
rear axle
nut
after adjust
the chain
tightness
to
10~20mm and con£rm
again
Notice:
When use new chain, check
both front
and rear sprockets
if they
are
still in
service
limit
and replace
them,
if necessary
During regular maintenance, check
the following
conditions
of the chain:
(1) Loose
pin
(2) Damaged
roller
(3) Rusty chain
link
(4) Twisted
or
snarled
link
(5) Excessive free
play
(6) Loose
chain
The sprocket is probably damaged,
if
any above-mentioned problems
on the
chain are
found.
Check
the following
items
for sprocket:
TNT300
38
To Next Page
