Benelli TRE-K899 - Page 39

35
Resetting the trip mileage counters
"Trip" value is reset by pressing twice the START button (with engine running and without pulling in the clutch).
CAUTION
The instrument panel has an integrated memory which retains all the parameters even when
the engine is not running. With exception of the clock and the Trip function which are reset, all
other parameters remain stored even in case the battery is disconnected.
Set "Chrono" / "Lap"
Move to the visualisation 2
To set the "Chrono" press the START button for less than one second.
To set the "Lap" from the "Chrono" position, press the START button for less than one second.
Each time the START button will be pressed for less than one second , the "Lap" function will indicate the "Chrono"
time, in the specic moment.
To stop the "Chrono" press the START button for less than one second.
To stop the "Lap" press the START button for three seconds at least.
To leave the "Chrono" position, press the START button for three seconds at least, moving to the 3 "Clock" / "Trip"
visualisation.
Set "Clock" / "Trip"
Move to the visualisation 3.
To set the timer, push the START button for two seconds at least.
The rst number starts ashing.
Press continuously the START button for the number regulation until reaching the number you desire.
Repeat the same operation to set the second timer number, the rst and the second minutes number.