36
Press the START button for three seconds at least, to stop the selection and the ashing.
To reset the "Trip" from the visualisation 3, press two times the start START button.
Set "Km" / "Mi"
From the 1 "Total" / "Trip" visualisation, when the motor is switched on, press the START button for at least ten
seconds.
The Km or Mi symbol will start ashing, press the START button to move to Km or Mi, press for at least two seconds
the START button, to select the measure unit you desire, moving automatically to the °C o °F selection, press the
START button for less than one second to select the temperature unit you desire.
Press the START button for at least three seconds, to conrm and exit from the Set "Km" / "Mi" visualisation.
Set "Service"
When the rst 1000 km (621.3 mi) will be reached and every 10000km (6213.6 mi) you will see the ashing Service
pilot light on the display, instead of the partial "Trip" for 10 seconds during the vehicle starting.
To reset the Service pilot light, press the START button for at least ten seconds until the pilot light is switched o.
OPERATION
To Next Page
Loading...
