BenQ DC C50 - Changing the Focus

BenQ DC 5530 User’s Manual
Using the DC C50
12
English
3.1.6. Changing the Focus
1. Set the mode dial to one of [ ], [ P], [ TV ], [ AV ],
[ M ], [ ], [ ], [ ] , [ ] and power on the camera.
2. Toggle the [ ] Focus button.
The selected focus mode is displayed on the LCD monitor.
[no indication]: Normal Auto Focus (0.8m to infinity).
[ ]: Macro Auto Focus (0.09m to infinity/Wide,
0.3m to infinity/Tele).
[ ]: The camera will focus on the subjects in a
distance of infinity to take photos.
[3m]: The camera will focus on subjects in a
distance of 3m to take photos.
[1m]: The camera will focus on subjects in a
distance of 1m to take photos.
3. Compose the picture.
4. Press the shutter down halfway,then press it down fully.
Note
•
When shooting a close-up in Macro mode, use the LCD monitor to compose your shot,
avoiding the off-center parallax phenomenon.
• There is not a distinct point (subject range) at which Normal mode is favored over
Macro mode; take in image in both optical modes and compare the results.
• After a Macro shot is taken DO NOT FORGET to reset the lens to the normal position.