BenQ DC 5530 User’s Manual
Preparing your DC C50 for using
4
English
PREPARING YOUR DC C50 FOR USING
2.1. Loading the battery
2.2. Using an AC Power Adapter:
Note
•
!Use only the specified battery type (Lithium Ion).
• !If you are not going to use the battery for an extended period of time, remove it from
the camera to prevent leakage or corrosion.
• !Avoid using battery in extremely cold environments as low temperatures can shorten
the battery life and reduce the camera performance.
You can use a Lithium Ion battery to power on the camera. Battery power is convenient for
capturing images or video clips.
1.!Make sure the camera power is off.
2.!Open the battery/SD Memory Card cover.
3.!Insert the battery in the correct orientation shown.
• Tilt the battery lock lever toward the strap
attachment and then insert the battery following
the orientation of the arrow on the batteryís label.
• Insert the battery as far as it can go.
4.!Close the battery/SD Memory Card cover.
• To remove the battery:
Open the battery/SD Memory Card cover and
then release the battery lock lever. After the battery
is slightly ejected, pull out the battery slowly.
Battery lock lever
1.!Make sure the camera power is off.
2.!Connect one end of the AC power adapter to the
DC IN 5V terminal.
3.!Connect the other end of the AC power adapter to a
power outlet.
Note
•
Make sure to use only the AC power adapter specified for the camera. Damage caused
by the use of an incorrect adapter is not covered under the warranty.
• !Using an AC power adapter while transferring images to your computer in order to
prevent unexpected automatic power off of the camera.
To Next Page
Loading...
Need help?
General
