Operation
28
6. You have successfully assigned a new
password to the projector. Remember to
enter the new password next time the
projector is started.
7. To leave the OSD menu, press Menu/Exit.
Disabling the password function
To disable password protection, go back to the SYSTEM SETUP: Advanced >
Security Settings > Change Security > Power On Lock menu after opening the
OSD menu system. Select Off by pressing / . The message 'INPUT
PASS WORD' displays. Enter the current password.
• If the password is correct, the OSD menu returns to the Security Settings
page with 'Off' shown in the row of Power On Lock. You will not have to enter
the password next time you turn on the projector.
• If the password is incorrect, the password error message displays lasting for three
seconds, and the message 'INPUT PASSWORD' displays for your retry. You
can press Menu/Exit to cancel the change or try another password.
Though the password function is disabled, you need to keep the old
password in hand should you ever need to re-activate the password
function by entering the old password.
To Next Page
Loading...
