Operation 49
FUNCTION DESCRIPTION
Picture Mode
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See "Selecting
a picture mode" on page 32 for details.
Reference
Mode
Selects a picture mode that best suits your need for the image
quality and further fine-tune the image based on the selections
listed on the same page below. See "Setting the User 1/User 2
mode" on page 32 for details.
Brightness
Adjusts the brightness of the image. See "Adjusting Brightness"
on page 33 for details.
Contrast
Adjusts the degree of difference between dark and light in the
image. See"Adjusting Contrast" on page 33 for details.
Color
Adjusts the color saturation level -- the amount of each color in a
video image. See "Adjusting Color" on page 33 for details.
This function is only available when a Video signal
is selected.
Tint
Adjusts the red and green color tones of the image. See
"Adjusting Tint" on page 33 for details.
This function is only available when a Video signal
is selected and the system format is NTSC.
Sharpness
Adjusts the image to make it look sharper or softer. See
"Adjusting Sharpness" on page 33 for details.
This function is only available when a Video signal
is selected.
2. PICTURE menu
To Next Page
Loading...
