32
Operations
Installing the ATV dongle
1. Remove the cap from the provided ATV dongle.
2. Place the projector on a flat and stable surface covered by a protective sheet with its right cover facing up. Make sure the speaker and strap are
facing toward you and the strap is on the right.
3. Slide to open the cover from the projector as illustrated.
4. Connect the power cable to the port on the side of the dongle ( ) and then insert the dongle into the designated HDMI port ( ) as
illustrated until you hear the clack.
How-to instruction
Install dongle
speaker strap
To Next Page
Loading...
