What to do if BenQ Joybee GP1 remote control does not work?
If your BenQ Projector's remote control isn't working, the possible causes are: * The battery is out of power. Replace the battery with a new one. * There is an obstacle between the remote control and the projector. Remove the obstacle. * You are too far away from the projector. Stand within 7 meters (23 feet) of the projector.
How to fix BenQ Joybee GP1 Projector that does not turn on?
If your BenQ projector isn't turning on, there might be a simple fix. Here's what to check: * There is no power from the power cable. Plug the AC adapter into the DC IN socket on the projector, plug the power cord into the AC inlet on the AC adapter, and plug the power cord into the power outlet. If the power outlet has a switch, make sure that it is switched on. * Attempting to turn the projector on again during the cooling process. Wait until the cooling down process has completed.
What to do if my BenQ Joybee GP1 Projector has no picture?
If your BenQ Projector shows no picture, it could be due to several reasons: * The video source is not turned on or connected correctly. Turn the video source on and check that the signal cable is connected correctly. * The projector is not correctly connected to the input signal device. Check the connection. * The input signal has not been correctly selected. Select the correct input signal with the SOURCE key on the projector or remote control.
How to fix a blurred image on my BenQ Projector?
If you're experiencing a blurred image with your BenQ Projector, try these solutions: * The projection lens is not correctly focused. Adjust the focus of the lens using the focus ring. * The projector and the screen are not aligned properly. Adjust the projection angle and direction as well as the height of the unit if necessary.
Steps for connecting the projector to a PC or Macintosh computer.
Step-by-step instructions for powering on the projector.
Guide to setting a new password for power-on lock.
Information on what to do if the projector password is forgotten.
Steps to access the main interface for USB media playback.
Detailed technical specifications including resolution, lamp, and dimensions.
Steps for connecting the projector to a PC or Macintosh computer.
Step-by-step instructions for powering on the projector.
Guide to setting a new password for power-on lock.
Information on what to do if the projector password is forgotten.
Steps to access the main interface for USB media playback.
Detailed technical specifications including resolution, lamp, and dimensions.
General| Brightness | 100 ANSI lumens |
|---|---|
| Contrast Ratio | 2000:1 |
| Projection Technology | DLP |
| Lamp Life | 20, 000 hours (Eco mode) |
| Connectivity | USB, VGA, Composite Video |
| Aspect Ratio | 16:9 |
| Inputs | Composite video, VGA, USB |
| Built-in Speaker | 2W |
To Next Page
