BenQ HT5550 - Controls and Functions

10 Introduction
Controls and functions
Projector & Remote control
1. SOURCE
Displays the source selection bar.
2. POWER
Toggles the projector between standby
mode and on.
ON/ Off
Toggles the projector between standby
mode and on.
3. BACK
Goes back to previous OSD menu, exits and
saves menu settings.
4. MODE, PIC MODE
Selects an available picture setup mode
when the projector detects a valid signal.
5. Arrow keys ( , , , )
When the On-Screen Display (OSD) menu
is activated, these keys are used as
directional arrows to select the desired
menu items and to make adjustments.
Keystone keys ( / , / )
Display the keystone correction page.
6. OK
Confirms the selected On-Screen Display
(OSD) menu item.
7. MENU
Turns on the On-Screen Display (OSD)
menu.
8. Keystone correction key
Displays the Keystone correction menu.
9. MOTION ENHANCER
Displays the Motion Enhancer 4K menu.
10. Picture quality adjustment keys (BRIGHT,
COLOR TEMP, GAMMA,
CONTRAST, COLOR MANAGE,
SHARP, DYNAMIC IRIS)
Display the menus for adjustments of the
appropriate picture quality values.
1
2
4
5
6
7
3
All the key presses described in this document
are available on the remote control or projector.
2 2
8
5
6
7
1
3
9
4
10
11
12
13
14
15
16
17
18
19