BenQ HT5550 - Page 27

27 Menu operation
INSTALLATION
Projector Position
Front/Front Ceiling/Rear/Rear
Ceiling
Test Pattern On/Off
Aspect Ratio Auto/4:3/16:9
12V Trigger On/Off
High Altitude
Mode
On/Off
Network Settings LAN Settings
Wired LAN
Status/DHCP/IP Address/Subnet
Mask/Default Gateway/DNS
Server/Apply
AMX Device
Discovery
On/Off
Network Standby
Enable Network Standby Mode/
Auto Disable Network Standby
Mode
SYSTEM SETUP:
BASIC
Language
Splash Screen BenQ/Black/Blue
Auto Off
Disable/5 min/10 min/15 min/20
min/25 min/30 min
Direct Power On On/Off
Menu Settings
Menu Position
Center/Top-Left/Top-Right/Botto
m-Right/Bottom-Left
Menu Display Time
Always On/5 sec/10 sec/15 sec/20
sec/25 sec/30 sec
Reminder Message On/Off
Source Rename
Auto Source On/Off
SYSTEM SETUP:
ADVANCED
Lamp Settings
Reset Lamp Timer Reset/Cancel
Lamp Timer
HDMI Settings
HDMI Range Auto/Full/Limited
CEC On/Off
Power On Link Off/From Device
Power Off Link Off/From Projector
Password
Change Password
Power On Lock On/Off
Key Lock On/Off
LED Indicator On/Off
Reset All Settings Reset/Cancel
ISF (input password)