BenQ MS536 - Lamp Timer Reset

41 Maintenance
6. Insert the new lamp into the lamp compartment and make sure it
fits in the projector.
7. Tighten the screws that secure the lamp.
8. Ensure the handle is fully laid flat and locked in place.
9. Replace the lamp cover by sliding it into place.
10. Tighten the screw that secures the lamp cover.
11. Restart the projector.
Resetting the lamp timer
12. After the startup logo, open the On-Screen Display (OSD) menu.
Go to the Advanced Menu - Settings > Light Settings and
press OK. Press to highlight Reset Light Timer and press
OK. A warning message displays asking if you want to reset the
lamp timer. Highlight Reset and press OK. The lamp time will be
reset to '0'.
• Loose screw may cause a bad connection, which could result in
malfunction.
• Do not over tighten the screws.
• Loose screw may cause a bad connection, which could result in
malfunction.
• Do not over tighten the screw.
• Do not turn the power on with the lamp cover removed.
• Do not reset if the lamp is not new or replaced as this could cause
damage.
7
6
(b)
(a)