40 Maintenance
11. Tighten the screw that secures the lamp cover.
12. .Connect the power and restart the projector.
Resetting the lamp timer
13. After the startup logo, open the On-Screen Display
(OSD) menu. Go to SYSTEM SETUP: ADVANCED > Lamp Settings and press OK. The
Lamp Settings page appears. Highlight Reset Lamp Timer and press OK. A warning message
is displayed asking if you want to reset the lamp timer. Highlight Reset and press OK. The lamp
time will be reset to “0”.
• Loose screw may cause a bad connection, which could
result in malfunction.
• Do not over tighten the screw.
Do not reset if the lamp is not new or replaced as this could cause
damage.
To Next Page
Loading...
