Bentone LMO14.113C2E - Service; Burner Service Schedule, Oil; Component Replacement Intervals

28
Bentone
8
9
10
7
6
7
6
5
7
1
2
4
6
3
7
6.5 Replacing the gasket seal (pump)
1. Disconnect hoses, oil pipes, and electrical cables
2. Loosen the pump (screw J)
3. Loosen the gasket seal’s locking rings
4. Remove the old gasket seal (2)
5. Install the new gasket seal
6. Connect hoses, oil pipes, and electrical cables
7. Test run and check seals
Components
1. Pressure adjusting plug assy (screw
driver slot)
2. Pressure regulator kit 10 - 28 bars
3. No cut-off” piston + short nozzle plug
4. Shaft seal kit (lip seal + protective
cone)
5. By-pass plug
6. G 1/4 gasket
7. G 1/4 steel plug
8. G 1/4 plastic plug
9. Filter
10. Cover gasket
!
Before obtaining access to electrical and fuel line components
allsupplycircuitsmustbedisconnected.