Need help?Do you have a question about the BEP 600-DCSM and is the answer not in the manual?
Details the comprehensive features of the 600-DCSM monitor.
Provides detailed electrical and physical specifications for the device.
Illustrates the physical arrangement of buttons, screen, and connectors.
Explains the function of each button on the device interface.
Describes the sequence and options presented upon first powering the device.
Details the primary display screen and its components after booting.
Guides on inputting custom labels and numerical values via the display.
Explains the process and prompts for saving configuration changes.
Presents the physical measurements of the 600-DCSM unit.
Details the function of each pin on the device's connectors.
Illustrates typical wiring configurations for different monitoring modes.
Steps to calibrate and set DC voltage measurement parameters.
Procedure for calibrating DC current measurements using a shunt.
Configuring battery capacity tracking using Peukert's equation.
Configuring tank level inputs and calibration modes.
Configuring inputs to monitor various onboard systems.
Setting up custom graphical displays for system status.
Configuring inputs to monitor pump operation and duration.
Setting up high/low level alarms for various inputs.
Adjusting screen brightness, timeout, and display modes.
Configuring how the meter cycles through status pages.
Detailed settings for each input type including label and display.
Configuring power-down, beep, password, and units.
Managing settings, firmware, and device resets.
To Next Page
General