Chapter 3 Configuration Page 25
Active State
The Active State is set to determine when the pump is on, either in Active High or Active low.
When the voltage is equal to or greater than ‘High Voltage’ setting, it is considered Active High.
When the voltage is equal to or less than ‘Low Voltage’ setting, it is considered Active Low.
High Voltage
The volts value for an Active High state.
Low Voltage
The volts value for an Active Low state.
Slosh Time
Liquid sloshing around a pump can cause the pump to quickly turn on and off. The slosh time can
be set to avoid recording these cycles.
Display on Mimic
Each pump can have an on or off indicator on the Vessel Status Page. Select yes to enable the
indicator.
Mimic x, y
These are the co-ordinates where the indicator will be displayed on the Vessel Status page. Use
the crosshairs to place the Indicator in the correct position.
Mimic Colour
There is a wide range of indicator colours to choose from, ensure the chosen colour is not going to
clash with the Mimic background image.
Reset
This will reset the pump cycles and accumulated time back to zero.
Alarms
All inputs have the ability to have a high or low warning alarm. Depending on what type of meter
configuration you are running, some of these alarms will be enabled by default.
Answering Alarms
Alarm
Window
Alarm
Icon
Label
To Next Page
Loading...