Chapter 4 Settings Page 33
Import Settings
Select Import Settings. Choose the file you would like to use, there may be more than one
depending on how many times the settings have been exported. Select Yes to upgrade meter.
Note: All stored settings will be lost when importing from memory stick so take caution before
upgrading.
Save Settings
The Save Settings function will save all current changes to the meter settings file.
Update Firmware
To ensure your meter is using the latest software, please check the BEP Marine website regularly.
To find out the current firmware version choose Main Menu > Setup > About.
To upgrade firmware insert memory stick in to USB socket with preloaded firmware named
‘application.tar.gz’. Follow the onscreen prompts until meter has finished upgrading and performed
a reboot.
Note: It is very important not to disconnect power supply from meter during a firmware upgrade as
it can cause the meter to become unusable.
Shutdown
This option will shut down the meter completely. Turn the meter supply off and then on again for a
reboot.
Colour Test
General colour test for LCD screen.
Factory Reset
At any time the meter can be restored to a factory state. This can be very helpful if settings have
been corrupted or the meter needs to be used in another application i.e. changing a DCM to a
SOM.
If the meter will not boot to a status page or the settings become corrupted reboot the meter and
hold the Down button. This will bring up the ‘Utilities’ menu where a Factory reset can be
performed.
Note: Please be aware that all stored settings will be erased when doing a factory reset.
Input Debug
Use this function to see a technical overview of all inputs.
To Next Page
Loading...