22
Maintain the engine according to the instructions in the
engine’s owner’s manual.
Check mounting bolts at frequent intervals for proper
tightness in order to prevent costly repairs. Make sure
your snowblower is in safe working condition.
Verify and adjust the pressure on the tires of the
subframe at 50 psi.
The tire pressure must be even on both sides.
Verify from time to time the wearing on the cutting
edge to make sure you do not wear out the base of
the snowblower’s chassis. This cutting edge is
reversible. Unscrew the bolts and turn the cutting
edge,
Reinstall with new carriage bolts 5/16’’ x 3/4’’ grade 5
and new lock nuts 5/16’’.
Clean the parts before aligning or replacing the pulley.
Apply some "Locktite" 2760 on the key and the set
screws. Tighten firmly.
-
-
-
-
-
-
-
Whether it is the snowblower auger, the fan or the
chute that is clogged, it is essential to follow these
instructions to the letter.
1. Disengage the electromagnetic clutch
2. Lower the snowblower to the ground and apply
the vehicle’s hand brake;
3. Stop the snowblower engine, remove the key and
wait for all the rotating parts to stop turning.
4. Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent
accidental starting;
: Always use the chute shovel supplied with
the snowblower in order to unclog the snowblower,
To Next Page
Loading...
