Model H79
20
The template is ruled in 1 inch squares with the sewing eld of the
machine subdivided by ¼” squares. Cut out the template along
the outside edge of the diamond shape. You may want to use a
hole punch to punch out the circles. To get to the center circle, just
barely fold the template so you can punch it. Or you can use a craft
knife and make cross cuts at each circle. These will indicate the
outside edge of the sewing eld and the center where the design
will start. You may also want to make a small notch in the top,
bottom and both sides to denote the horizontal and vertical center
lines. These horizontal and vertical center lines correspond with
the arrows of the hoop.
NOTE: The sewing eld of your Model H79 Embroidery Machine is 100mm x 100mm or 3.93
inches. The template is marked in inches, therefore the design will always t within this area.
Mark the horizontal and vertical lines for the center of the design on the
garment to be embroidered. Use the template to make sure the
centers are lined up with the center of the sewing eld.
Operation
H79_Manual.indd 20H79_Manual.indd 20 10/6/2008 4:29:07 PM10/6/2008 4:29:07 PM
To Next Page
Loading...
