Bernette H79 - Error Codes and Troubleshooting Guide; Machine Error Codes Explained

Model H79
39
Error Codes and Troubleshooting
Error Codes and Troubleshooting
Error Codes
Error Codes and Troubleshooting
Error Codes and Troubleshooting
Error
11
12
13
14
15
16
22 & 23
25
bob
Problem
Needle is in the fabric and
the hoop cannot move.
Card was removed.
Upper thread broken.
Presser foot needs to be
lowered.
Presser foot needs to be up.
Bobbin Winder is engaged.
Design is too large to sew.
-X limit reached.
Bobbin winder engaged.
Solution
Turn the Balance Wheel until
the needle is at its highest
point.
Do not remove the card
while the machine is on.
Re-thread the needle or
check to see if the thread is
not in all the tensioners. If
this happens at the begin-
ning of the design, hold the
thread taut when you press
the START/STOP button.
Lower the presser foot with
the presser foot lever
Raise the presser foot with
the presser foot lever.
Push the Bobbin winder to
the left to disengage it.
Choose another design or
make the design smaller us-
ing the software.
Start design in center of
hoop and trace to make sure
design will  t and restart
design.
Move bobbin winder to the
left to disengage it.
continued on next page
H79_Manual.indd 39H79_Manual.indd 39 10/6/2008 4:29:13 PM10/6/2008 4:29:13 PM