Model H79
29
3. After trimming, lower the presser foot and press the START/STOP
button again to start the machine. The machine will stop when
it completes all the stitching with this thread color. During the
sewing process, the display will read =## signifying the percentage
of completion of the design. For example, =22 is displayed in the
LED means that the design is 22% complete.
4. When the color is complete, the LED screen will display c## (c02
for the second color in the design, c03 for third color in the design,
etc). depending on the sequence of the color. This lets you know
which color to change to according to the code sheet of the
design.
5. To change the color of the upper thread, raise the presser foot and
clip the upper thread close to the embroidery AND at the thread
spool. Pull the upper thread from the needle to remove and
discard it.
6. Thread the machine with the new color.
7. Lower the presser foot. While holding the thread tail, press START/
STOP to sew the next color section.
8. Repeat until the design is completed. The LED will show 100 to
represent 100% completion when the design is complete.
Operation
H79_Manual.indd 29H79_Manual.indd 29 10/6/2008 4:29:10 PM10/6/2008 4:29:10 PM
To Next Page
Loading...
