Model H79
34
1. It is a good idea to turn o the power if you are not in the middle
of an embroidery design. If you have to change the needle in the
middle of a design, be very careful not to push the START/STOP
button during the process of changing the needle.
2. Lower the presser foot to its lowest position and raise the needle to
its highest position by turning the balance wheel toward you. This
will facilitate the removal and replacement of the needle.
3. With the 3- way screwdriver tool provided in the accessory kit,
loosen the needle screw (counterclockwise) until the needle can be
removed from the machine.
Operation
H79_Manual.indd 34H79_Manual.indd 34 10/6/2008 4:29:11 PM10/6/2008 4:29:11 PM
To Next Page
Loading...
