Bernette H79 - Page 8

Model H79
8
8. To center a selected design in the hoop press .
9. To enter or accept a design number shown in the LED window
press
.
10. Toggles between Internal memory and a Memory Card.
## will be displayed on the LED when the Internal memory of
the machine is accessed. C## signi es Card Memory has been
accessed.
11. When lit, indicates an error—see LED for error
number. In some cases you may have to press the START/STOP
button to see which error has occurred.
12. When lit, indicates machine power is on.
13. When lit, indicates a color change—see LED
for color change number. This will be displayed as a lower case “c”
followed by the number of the sequence of the color.
14. When lit, indicates thread break.
15. When lit, indicates machine is in sewing mode.
Introduction
Introduction
H79_Manual.indd 8H79_Manual.indd 8 10/6/2008 4:29:04 PM10/6/2008 4:29:04 PM