Bernina Bernette Funlock b44 - HOW TO OPEN LOOPER COVER; Principal Parts Behind the Looper Cover; PREPARATION TO SEWING; Power Switch Operation

10
OFF
ON
2
1
2
3
6
4
5
1
Principal Parts behind the Looper
Cover
PREPARATION TO SEWING
HOW TO OPEN LOOPER
COVER
(1) Upper looper
(2) Upper knife (moveable)
(3) Standard presser foot
(4) Fixed position lower knife
(5) Lower looper
(6) Rolled Hem lever
Power Switch
– Connect the controller/electric plug to the
machine receptacle.
– Plug power line into electric outlet.
– Push " l " mark side to turn "ON"
– Push "O" mark side to turn "OFF"
1. Push the cover to the right as far as it will go.
2. Pull cover down toward you.
CAUTION:
Be sure to turn off power switch.
CAUTION:
Be sure looper cover is closed when sewing.
CAUTION:
Use only foot controller provided with this
machine. (Type 4C–316B for USA & CANADA
only). Be sure to make reference to “Warning”
on following Page.
Foot Controller
– To run the machine and control the speed,
press the controller.
– The harder you press, the faster the machine
will sew.
– To stop the machine from sewing, remove your
foot from the controller