Bernina Bernette Funlock b44 - Procedure to Remove Needles; Procedure to Insert Needles

16
To Remove Needle(s)
Set seam width finger knob to R to retract the seam
width finger and set it for rolled hem.
– Turn the hand wheel toward you until the
needles are at their highest position.
– Place a thick piece of fabric [such as felt] under
the presser foot.
– Lower the needles halfway into the fabric.
– Loosen, but do not remove the needle set
screws with the small allen screwdriver. Hold
the needles with your fingers and raise the
needle bar. The needles will remain in the
fabric.
(A) Left needle (LN)
(B) Right needle (RN)
To Insert Needle(s)
– Hold the needle with the flat surface (1) to the
back.
– Insert the needle into the needle socket as far
as it will go.
– When inserting a needle, if you first lower it
down into the hole in the stitch plate it will line
up with the needle socket. Then direct it
upwards.
B
A
1
2
3
A
B
B
A
BAB
B
A
1
2
3
A
B
B
A
BAB
PLEASE NOTE:
Be sure to disconnect the machine from the
electric outlet before removing needle(s).
PLEASE NOTE:
When inserting needles into the (A) or (B)
sockets it is necessary to loosen (3) both (A)
and (B) Allen Screws.
After inserting the needles equally tighten both
Screws (2).