Bernina Bernette Funlock b44 - Threading the Overlock Right Needle (Green)

 23
Threading the Overlock Right Needle
(Green)
(B On Needle Clamp)
– Thread the right needle as indicated (1)–(9).
– Raise Presser foot to release Tension discs.
3
2
3
4
1
1
2
2
5
6
7
8
9
3
3
2
3
4
1
1
2
2
5
6
7
8
9
3
CAUTION:
Be sure to turn off power switch.
– Pass thread from back to the front through the
thread guide (1).
– Thread the top cover thread guide by pulling the
thread towards the left until it slips under guide
(2). Then pull thread along the right side of
button as illustrated.
– While holding thread with fingers, pass it
between the tension discs and pull thread down
to make certain it is properly located in between
the tension discs (3).