Bernina Bernette Funlock b44 - Threading the Overlock Left Needle (Yellow)

24
Threading the Overlock Left Needle
(Yellow)
(A On Needle Clamp)
– Continue to thread points (4)–(9).
– Thread the left needle as indicated (1)–(9).
– Raise Presser foot to release Tension discs.
– The position of the thread must be behind the
thread guide.
– Draw about 4" (10 cm) of thread through needle
eye towards the rear of machine.
– Place the thread to the back, under the presser
foot.
Before threading eye of needle, slip thread behind
thread guide located on the bottom of the needle
clamp.
– Thread the eye of the right needle (9).
1
9
7
8
1
2
3
4
5
7
6
8
9
4
5
6
7
8
9
10cm
(4”)
1
9
7
8
1
2
3
4
5
7
6
8
9
4
5
6
7
8
9
10cm
(4”)
1
9
7
8
1
2
3
4
5
7
6
8
9
4
5
6
7
8
9
10cm
(4”)
1
9
7
8
1
2
3
4
5
7
6
8
9
4
5
6
7
8
9
10cm
(4”)
CAUTION:
Be sure to turn off power switch.
PLEASE NOTE:
Slip thread into the rear slot on the thread guide
(5) and bottom slot of take–up lever cover (6).
Then slip thread into the right slot on the thread
guide (7), and into the right slot on the thread
guide (8).
PLEASE NOTE:
Use of tweezers in the accessory case will make
needle eye threading easy.
– Pass thread from back to the front through the
thread guide (1).