Bernina Bernette Funlock b44 - Page 25

 25
10cm
(4”)
3
2
2
3
9
7
8
7
6
5
4
8
9
10cm
(4”)
3
2
2
3
9
7
8
7
6
5
4
8
9
10cm
(4”)
3
2
2
3
9
7
8
7
6
5
4
8
9
– Thread the top cover thread guide by pulling the
thread towards the left until it slips under guide
(2). Then pull thread along the right side of
button as illustrated.
– While holding thread with fingers, pass it
between the tension discs and pull thread down
to make certain it is properly located in between
the tension discs (3).
– Continue to thread points (4)–(9).
Before threading eye of needle, slip thread behind
thread guide located on the bottom of the needle
clamp.
– The position of the thread must be behind the
thread guide.
– Draw about 4" (10 cm) of thread through needle
eye towards the rear of machine.
– Place the thread to the back, under the presser
foot.
– Thread the eye of the left needle (9).
PLEASE NOTE:
Slip thread into the rear slot on the thread guide
(5) and bottom slot of take–up lever cover (6).
Then slip thread into the left slot on the thread
guide (7), and into the left slot on the thread
guide (8).
PLEASE NOTE:
Use of tweezers in the accessory case will make
needle eye threading easy.