Bernina Bernette Funlock b44 - CHAINING OFF AND TEST SEWING

 31
1
1
1
1
1
1
1
1
– When the machine is completely threaded,
bring all of the threads across the stitch plate
and slightly to the left under the presser foot.
– Hold the threads and apply a slight tension.
– Turn the handwheel toward you 2 or 3 complete
turns to start the thread chain.
– Lower presser foot.
– Continue holding the chain and press on the
foot controller until the chain is 5–7.5 cm (2–3")
in length.
– Place fabric under the front of the presser foot
and sew a test sample.
– At the end of the sample, continue to run the
machine with the presser foot down until the
chain reaches 15–20 cm (6–8") in length.
– Cut thread.
PLEASE NOTE:
Do not pull on the fabric while sewing as this
may deflect the needle, causing it to break.
PLEASE NOTE:
In case it is difficult to chain off when chain
stitching, pull the fabric lightly backward.
PLEASE NOTE:
Anytime you have rethreaded the machine
always chain off and sew a text sample to test
tensions and make adjustments as necessary.
Information
A mark (1) to indicate the needle location is provided
on the presser foot fitted on this machine. Use this
mark as a guide when sewing.
CHAINING OFF AND TEST
SEWING