Bernina Bernette Funlock b44 - Additional Rolled Hemming Information

40
• To secure the rolled hem thread chain
– Apply a small drop of liquid seam sealant to the
end of the seam. Allow to dry, then cut the chain
close to the stitches.
Additional information about rolled
hemming
– Hold the thread chain when you begin sewing to
keep it from curling into the seam.
– Place a slight tension on the material in the
sewing direction and a finer seam finish can be
obtained.
– The minimum overlock stitch width that can be
obtained for rolled hemming is approximately
1/16" (1.5 mm) since the cutting width cannot
be set below 9/64" (3.5 mm).
PLEASE NOTE:
Test the liquid seam sealant for color fastness
before use.