Bernini Be242 - Page 15

Be242 Be242RB Be242-22 OEM's Manual V4.X.XX - March - 2023 page 15
15
Table 7.04 - ALARM OPTIONS Note: [ xx " ] = seconds, [ xx ' ] = minutes, [ oFF ] = disabled
Parameter Code & Description
Default
Min
Max
Options
P.33
Alarm bypass (for Oil, Temperature, Auxiliary 2-
3-4 alarms)
[ 5" ]
2 secs
90 secs
-
P.34
Fail to stop alarm control (oFF = inhibited,
on = enabled)
[oFF]
-
-
[oFF]/ [on]
P.35
Emergency contact type (Input JH1-JH4). It
generates the alarm [Er.08].
[n.c.]
-
-
[n.o. / n.c.]
P.36
No fuel bypass timeout (it starts to count when
you activate the Low Fuel Input, terminal #9. It
shuts down the engine after timeout).
[ 5' ]
15 secs
99 mins
[oFF]
P.37.38
NOT USED
[ oFF ]
P.39
Engine Temperature Switch type (input # 12)
[n.o.]
-
-
[n.o. / n.c.]
Table 7.05 - MISCELLANEOUS Note: [ xx " ] = seconds, [ xx ' ] = minutes, [ oFF ] = disabled
Parameter Code & Description
Default
Min
Max
Options
P.40
EJP time
[ 5" ]
1 sec
99 mins
-
P.41
Periodic Test interval (see 16.10)
[oFF]
2 hours
9999 h
[oFF]
P.42
Periodic Test duration (see 16.10)
[ 5' ]
1 min
99 mins
-
P.43
Test timeout ([OFF]= no timeout). It limits the
running time in case of a TEST initiated by a
MODBUS command. Idle speed control (see
application note in section16.60)
[ 5' ]
1 min
99 mins
[oFF]
Ser.1
Ser.2
Ser.3
Maintenance SERVICE 1 / 2 / 3
(for the use, see section 16.40)
The alarm generated by these parameters
only provides a warning.
[oFF]
1 h
9999 h
[oFF]
P.47
Rental Contract Setting (see section 16.40)
[oFF]
1 h
9999 h
[oFF]
P.48
NFPA - 110 Level 1&2
[on]
-
-
[on]/[oFF]
P.49
NOT USED
[ 1]
P.50
Horn timeout (see section 8.0)
[ 5" ]
5secs
15 mins
[oFF]
P.51
Hour Counter set (over 9999, a dot will appear
to indicate a value multiplied by 10. Example
3250. will indicate 32500 hours. In this case
the resolution is 10 hours).
[ 0 ]
0 h
50.000
[oFF]