08 Bertec Corporation Instrumented Treadmill Manual
Safety Information and Labeling
This label on the Electronic Control Unit warns users to not
open the cabinet due to high voltage and electric shock risk.
Each treadmill has four pinch point labels located on the four
corners on top of the treadmill base. These labels indicate
areas where body parts can be pinched or injured.
These labels list the serial numbers for the treadmill and the
Electronic Control Unit.
If labels begin to wear to the point that they are illegible, contact Bertec Corporation for new ones.
Intended Use
Operation of the treadmill outside of the scope of intended use carries with it the risk of injury to the operator and subject and
risk of damage to the treadmill system.
The intended uses are as follows:
1. The treadmill is intended for use in the areas of research and rehab using human subjects wearing typical footwear or no
footwear. The treadmill is not intended to be used with any type of footwear having a metal ground contact component, i.e.
metal sports cleats. The treadmill is not intended for use with wheelchairs.
2. Bertec Corporation is not responsible for verication or validation of customer’s research protocols, application for and
attainment of required IRB’s, or any other conclusions regarding the validity of the research protocol or data generated to
facilitate such research.
3. Normal operating conditions such as those found in a typical clinical or ofce environment at temperature ranges and limited
uctuations found in a typical indoor and climate controlled ofce environment. Customer ensures proper power supply,
grounding, and adherence to local, regional and national building and electrical code standards required to maintain such
environmental standards.
4. Not intended for household use.
To Next Page
Loading...