ENGLISH Gold/Plus/Easy refrigerated cabinets
70
Ed. 12/2020
3.3.4 Enabling manual defrost mode
–
Make sure that the keypad is not locked and that there are no procedures running.
– Press and hold the A key for 4 seconds to start the manual defrost cycle.
Note: if the evaporator probe serves as a defrosting probe (i.e. if parameter P4 is set to 1 – see datasheet) and if, when
defrosting is activated, the evaporator temperature is above the temperature set under parameter d2 (see datasheet),
defrosting will not be activated.
3.3.5 Loading products
a
IMPORTANT
Wait until the desired set temperature on the control panel has been reached before loading products
into the appliance.
– For maximum appliance efficiency, load the products following the instructions given in the section “Correct use”.
To Next Page
Loading...